Detachable magazine systems have been steadily gaining popularity for use in precision, tactical and competition bolt action rifles. Until a few years ago, the choices of systems were limited. Now, shooters have a wide range of bottom metal to select from. One of our favorites in the Surgeon detachable magazine system. Using the proven Accuracy International AICS magazine, the Surgeon system includes two precut aluminum pillars that ensure proper spacing of the bottom metal which in turn provides reliable operation and feeding.
Surgeon provides an inletting diagram with their system, however, we have found that sending the stock out to be inletted, provides superior results for everyone except the most experienced machinists. Our McMillian stock shown here was inletted by McMillian for a nominal fee and relatively short turn around time.
During installation we will be skim bedding the stock, bedding the recoil lug and gluing the pillars in place. We do not make a barrel bed, or bed the chamber end of the barrel. We have found that leaving clearance on this area provides a stress free installation and promotes accuracy.
Brownells provided the following for use in this project:
The contents of Rifleshooter.com are produced for informational purposes only and should only be performed by competent gunsmiths. Rifleshooter.com and its authors do not assume any responsibility, directly or indirectly, for the safety of the readers attempting to follow any instructions or perform any of the tasks shown, or the use or misuse of any information contained herein, on this website.
The rifle is now ready to be reassembled and taken to the range.
Modular Driven Technologies (MDT) Elite Sniper System (ESS) chassis review I’ve been reviewing products from Modular Driven Technologies (MDT) since they were founded. Their product line started with the TAC21 and expanded of to include […]
Custom 1911 Project: Part 5- milling slide for low mount sights, presented by Rifleshooter.com and Brownells This is the fifth installment of our Custom 1911 project- in this post we are going machine the slide to […]
We’ve been using different sprayed on heat cured finishes here for a while. Our favorite is Cerakote, a two-part heat cured ceramic based epoxy. Cerakote provides a durable protective finish that we have come to […]